Owner Manual

FIGURE 2

STEP:2

Install End Leg Panels (P4) onto the Legs using Bolts (H3), Lock Washers (H5) and Flat

Washers (H2) as shown in FIGURE 2.

Tighten Bolts (H1) from STEP 1 and Bolts (H3) at this time.

Screw P5 Leg Levelers into the bottom of each leg as shown in FIGURE 2.

Connect 4 Leg Connecting Wires from (P2) and (P3) Legs to Junction Box Ports (C3) as per

the ELECTRICAL CONNECTIONS & SPARE PARTS DRAWINGS on the next page and below.

H5 M8 Lock Washer8 pcs -

PARTS REQUIRED:

H3 8 x 40mm Allen Head Bolt 8 pcs -

P4 End Leg Panel2 pcs - P5 Leg Leveler4 pcs -

H2 8.5 x 22mm Flat Washer8 pcs -

C3 Junction Box

P3 Leg P3 Leg

C2 A/C Adapter

Factory installed

P2 Leg

G04801

P3C5 C4

C6 C7

P2 P3

NOTE: lightly push in on all connections to insure good connections.

All male to female connectors will only connect one way depending

on the tabs and slots of each.

Please closely inspect both the male and female connectors

to determine how to correctly plug the two together