Owner's Manual

ATOLL ELECTRONIQUE
OWNER’S MANUAL ~ AMPLIFIER
AM100 Sig
ATOLL ELECTRONIQUEPage 5Page 4
1) Amplifier input.
2) Amplifier output (to another power
amplifier for bi-amp).
3) Right channel output.
4) Trigger 12V input
(*)
.
5) Left channel output.
6) General power plug and ON/OFF
button (with internal fuse).
7) Power indicator led.
CONNECTING
DETAIL OF FUNCTIONS
1 2 3 54
7
(*)
Trigger Input: This input allows the control ON/OFF of your amplifier simultaneously
to any device with a 12V trigger outlet. In order that the system is operating, the ON/
OFF button of your Amplifier must remain in position OFF (0). If the switch is in the ON
position (1), the amplifier will work but not the Trigger function.
Trigger cable must be a Male to Male jack plug 3.5mm (1/8”).
To transform your Power Amplifier from Stereo to Mono, you have to push the switch
a
placed inside the appliance as shown below:
MONO BRIDGE MODE
Warning: for the AM100 Signature, bridged mono mode is not recommended on
speakers with an impedance of less than 6 Ω.
Warning: be sure
that your amplier
is unplugged
and that no other
appliance is plug
in during this
operation.
a
(Configuration: 1 Preamplifier and 2 mono amplifiers).
CONNECTING
PREAMP
AMP 2
AMP 1
DO NOT
OPEN
NE PAS
OUVRIR
SERIAL NUMBER
NUMERO DE SERIE
MADE IN FRANCE
FABRIQUE EN FRANCE
DO NOT
OPEN
NE PAS
OUVRIR
SERIAL NUMBER
NUMERO DE SERIE
MADE IN FRANCE
FABRIQUE EN FRANCE
DO NOT
OPEN
NE PAS
OUVRIR
SERIAL NUMBER
NUMERO DE SERIE
MADE IN FRANCE
FABRIQUE EN FRANCE
L
R
PRE-OUT
L
R
AMPLI
IN OUT
L
R
AMPLI
IN OUT
+ –
POWER
POWER
RIGHT
+
RIGHT
+
LEFT
+
LEFT
+
+ –