Operation Manual

2-10
ITEM
NO.
INTER-
VAL
LOCATION
PROCEDURE
NOT FULLY
MISSION
CAPABLE IF:
CHECK/
SERVICE
10 Before/
After
Viewed Image
NOTE
Operator may use the TS-4348/UV to check resolution (paragraph 2.2.2).
Refer to paragraph 2.2.3. to inspect for op- erational defects.
Flickering, flashing, edge glow, or shad- ing is observed.
11
Before/ After
HEADMOUNT Straps/Pads
NOTE
If any of the following items are damaged it does not cause the entire end item to be “not fully mission capable”. However, the damaged item should be replaced as soon as practical to restore full capability of the system. Inspect for cuts, tears, fraying, holes, cracks, or defective fasteners.
D a m a g e c a u s e s straps or pads to be unserviceable.
12 Before/
After
Socket Inspect for dirt, dust, or corrosion.
Insert monocular latch into socket to verify secure attachment of monocular to head- mount. If necessary, clean socket with water.
D a m a g e d , l a t c h won’t lock or is too loose.