Operation Manual

ManualsBrandsATN ManualsVideoPVS-14

2-7

ITEM

NO.

INTER-

VAL

LOCATION

PROCEDURE

NOT FULLY

MISSION

CAPABLE IF:

CHECK/

SERVICE

3.

Cont.

Before/

After

Battery Cap/

Housing

Cont.

Remove battery and turn the power switch

from RESET/OFF to ON to IR/PULL. Each

position should have a definite stopping

point. Inspect for broken or missing knob.

Install battery per paragraph 2.6. and check

IR source (and momentary IR source, if so

equipped) functions by following the oper-

ating instructions in paragraph 2.22.

Check the high light cut-off with daylight or

bright room light (not fluorescent light) by

placing the lens cap on the objective lens.

Turn monocular ON and observe that the

system cuts OFF within 70 ±30 seconds.

Power switch has

no definite stopping

points or knob is bro-

ken or missing.

IR source does not

work.

If damaged, refer to

higher level of main-

tenance.