0x65Z ARMY MILDOT u s e r ` s g u i d e AMERICAN TECHNOLOGIES NETWORK CORP.
Lens cap push-button Focusing system Reticle brightness adjustment Battery housing ±5 Diopter Flip-up lens cap ATN mounting system Elevation Fixation screw of the locking mechanizm Bullet drop compensator with interchangeable cams Windage The information in this manual furnished for information use only, is subject to change without notice, is not to be construed as a commitment by ATN Corp. ATN Corp.
APPLICATION The ATN 10x65Z-Army Mil-Dot is not an evolution but a revolution, not an improvement, but a breakthrough. For years the best names in optics were aspired to produce a balanced large aperture tactical scope. Large aperture renders into large Exit Pupil. Large Exit Pupil means longer operating hours and better performance in low light conditions and in “stressed” environment.
OPERATING MOUNTING 1. Slightly loosen the fixing screws on the weaver rail built into the scope. 2. Place the scope on the dovetail mount of the fire arm making certain that the mount aligns with the receptor attachment screw groove. Adjust as necessary. 3. Tighten the fixing screws. NOTE: Receptor attachment screws may need to be tightened after continuous shooting.
WINDAGE AND ELEVATION The vertical and horizontal adjustments for the 10x65Z can be achieved by turning the elevation and windage adjustment mechanisms (remove dust caps first). Each click equals to 1/8 inches at 100 yards. When reaching the maximum of rotation do not use force. Windage Lines Bullet drop compensator 4. Turn the windage and elevation handles through the number of clicks necessary for an amendment. The number of clicks should be read from the scale with respect to the chosen line.
The space between dot centers subtends one milliradian(mil). One mil. subtends 3.6 inches at 100 yards or 36 inches at 1,000 yards. To use this system effectively you must know the size of the target. By measuring the height or width of a known (or approximately known target size) in milradians using the reticles, the target distance can be calculated as follows.
WARRANTY LIMITATION OF LIABILITY ATN will not be liable for any claims, actions, suits, proceedings, costs, expenses, damages or liabilities arising out of the use of this product. Operation and use of the product are the sole responsibility of the Customer. ATN’s sole undertaking is limited to providing the products and services outlined herein in accordance with the terms and conditions of this Agreement.
For customer service and technical support, please contact American Technologies Network Corp. North American Office 20 S. Linden Ave. Suite 1B, South San Francisco, CA 94080 phone: 800-910-2862, 650-875-0130; fax: 650-875-0129 European Office phone: 44(0)870-0111286, fax: 44(0) 845-3349142 The following countries can use our toll free number 00 800 9102-8620 Austria, France, Germany, Holland, Italy, Spain, Sweden, Switzerland www.atncorp.
