Installation manual
MonoSolar & Solar Panels Installation Manual Page 3 of 29
Contents
1. Introduction and Location 4
1.1 Introduction 4
1.2 Selecting the location of the Solar Panel and Tank 5
2. Installing Roof-Integrated Solar Panels 6
3. Installing Roof-Mounted Solar Panels 8
4. Installing Solar Panels on Flat Roofs 8
4.1 Fixed Frame Method 8
4.2 Ballast Frame Method 10
5. Installing the MonoSolar 11
5.1 Requirements 11
5.2 Assembly 11
5.3 Connecting the panel 15
5.4 Connecting the Domestic water circuit 15
5.5 Installing the Panel Sensor 16
5.6 Electrical Wiring/connections 16
5.7 Connecting the display to the wall 16
5.8 Power Supply 17
5.9 Filling the System 17
5.10 Commissioning 17
6. Taking the MonoSolar out of service 18
6.1 Switching off 18
6.2 Draining the system – Draining the tank 18
6.3 Draining the system – Draining the heat exchanger 18
7. Warranty 18
8. Inspection, Maintenance and Faults 19
8.1 Inspection and Maintenance 19
8.2 Fault Diagnosis 20
9. Technical Specifications 21
9.1 Technical Specification of Solar Panels 21
9.2 Technical Specification of MonoSolar 22
10. Connections to Hot Water Systems 23
10.1 Connection to Atmos Compact Combi N30K
Condensing Gas Boiler 23
10.2 Connection to Atmos Multi (24/80, 24/80 Plus, 32/80)
Condensing Gas Boiler 24
10.3 Connection to Unvented Indirect HW System
(Mains Pressure) 25
10.4 Connection to Vented Indirect HW System 26
APPENDIX 1 MonoSolar Circuit Diagram 27
APPENDIX 2 MonoSolar Commissioning Check List 28
APPENDIX 3 Solar Panel Labelling 29