Instructions / Assembly

Mounting
01 02
06
0403
07
Use mounting screws
that are at least 1 inch
in length.
The water heater must be installed in a manner that prevents
contact with combustible materials. Keep combustible materials at
least two feet away from the heater and hot water output pipe.
The water heater and hot water outlet pipe must be securely out of
the reach of children to prevent tampering with controls or contact
with an extremely hot pipe.
The mounting surface
must be solid and secure.
The unit must be installed
in an upright position with
the water inlet and outlet
at the bottom.
Make sure the unit is
level prior to securing the
mounting screws.
If installing the heater on an upper oor or in an attic, be sure
installation is in compliance with local code. Install a drip pan
with drainage, or a leak detector and automatic shutoff valve, to
prevent damage in case of a leak.
Assembly Instructions
Run water through the
unit for one minute, and
make sure there are no
leaks
01
07
06
02
05
04
03
Remove the appliance
covers (Figure 2).
Connect the Pressure Relief Device (PRD)
to the unit (Fig1)
Note: IMPORTANT – do not discard
this step. A PRD must be installed.
Connect the incoming water line
to the heater inlet (on right side),
and connect the outgoing water
line to the heater outlet.
Use a hose that can withstand
pressure up to 8 bar (Figure 5).
Mount the unit on the wall with 4 screws
at the marked points. (Figure 4)
Make sure the unit is horizontally level,
with water inlets and outlets at the
bottom. (Figure 5)
Disconnect the cable
from the PCB within
the unit. (Figure 3)
Make sure power to the unit is shut off by means of the dedicated
circuit breakers on the main electrical panel.
Run the power cable wires from the circuit breakers on the main
electrical panel to the water heater.
Connect the power cable to the terminal block within the unit.
Make sure the correct breaker size and wire gauge have been used.
Make sure all wire connections are tight and secure.
Make sure the unit is connected to a ground in accordance with
applicable codes. (Figure 6)
65
05
Do not install the unit
above electrical boxes
or junctions.