Installation Guide

Assembly Instructions

Run water through the

unit for one minute, and

make sure there are no

leaks

Disconnect the cable

from the PCB within the

unit. (Figure 3)

Remove the appliance covers

(Figure 2).

Connect the incoming water line

to the heater inlet (on right side),

and connect the outgoing water

line to the heater outlet.

Use a hose that can withstand

pressure up to 8 bar (Figure 5).

Mount the unit on the wall with 4 screws at the marked points.

(Figure 4)

Make sure the unit is horizontally level, with water inlets and

outlets at the bottom. (Figure 5)

Make sure power to the unit is shut off by means of the dedicated

circuit breakers on the main electrical panel.

Run the power cable wires from the circuit breakers on the main

electrical panel to the water heater.

Connect the power cable to the terminal block within the unit.

Make sure the correct breaker size and wire gauge have been used.

Make sure all wire connections are tight and secure.

Make sure the unit is connected to a ground in accordance with

applicable codes. (Figure 6)