Warranty

10. Operation Instructions

Improper use of this electric faucet may cause scalding.

If you will not be using the faucet for an extended period,

especially when temperatures are cold and freezing, it

is recommended that you disconnect the power cable

and drain the faucet.

Model COMFORTAP 1.8kW

Make sure the faucet handle is in the OFF position. Then

plug the electric cable into the power outlet.(Fig. 8b)

9. After completing the plumbing and electrical installation, and

when operating the appliance for the rst time, allow cold

water to ow through the faucet for at least 20 seconds to

ush the water line of any debris. After thoroughly ushing

the line, you can complete the electrical installation.

Operation of the HOTAP water heater tap is simple.

• When the handle is fully forward (9 o’clock position), the

appliance is shut o. (Fig. A)

• When the handle is in the middle facing up (12 o’clock

position), cold water ows the strongest. (Fig.B)

As the handle is pushed back, the red indicator LED

lights up and warm water begins to ow. (Fig.C)

• When the handle is fully backward (3 o’clock position),

water temperature is the highest, but ow rate is the

lowest. (Fig. D)

To maintain the hottest temperature, you must keep the

ow rate low.

Shut o Position

Max ow

Cold water

Max. ow

Warm water

Min. ow

Hottest Temp.

Fig. A

Fig. C

Fig. B

Fig. D

11. Maintenance

WARNING! Always disconnect the faucet from the power supply by means of the circuit

breaker on the main electrical panel before performing any service on the appliance.

To ensure consistent water ow, it is recommended that you periodically remove scale and dirt

that may build up in the mesh screen lter in the inlet.

Periodically unscrew the aerator and remove scale and dirt that may have accumulated in the

aerator.