Hot Water on Demand Installation and Operation Guide COMFORTAP/HOTAP Water Heater Faucet COMFORTAP 1.8kW www.atmorusa.com Cat. No. 197575 HOTAP 3.
Important Safety Guideline SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE. Definitions: Safety Alert Symbols and Words This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
Contents 1. Packing List ........................................................................................................... 4 2. Safety Instructions................................................................................................. 5 3. HOTAP Features..................................................................................................... 6 4. Safety Features...................................................................................................... 6 5.
1.
2. Safety Instructions • • • • • • • • • • • For your satisfaction and safety, read this guide thoroughly before installing and using the HOTAP water heater faucet. For best performance, we recommend this appliance be installed by a licensed electrician and in accordance with all electrical and plumbing codes applicable to your area, and as specified in this guide. Failure to comply with the safety, installation or operating instructions will void the product warranty.
• Make sure the hole through the counter is large enough for the electric cable to pass freely through it. The cable should also pass easily through the notches in the pedestal and rubber pads, as shown in the installation diagrams. Failure to install the electric cable properly could cause the wires to fray, which will void the appliance’s warranty. If you detect damage to the wiring within the faucet, you must contact the manufacturer. .
5. Technical Specifications Item Specification COMFORTAP Power HOTAP 1.8 kW Hot water flow rate 3 bar 3 kW 0.7 – 1.5 gallon/minute Voltage 120 V Rated current 15 A 25 A Rated frequency 50/60 Hz Recommended cable size Overheat protection 12 AWG 16 AWG 120°F 158°F IP rating IP25 Minimum active pressure 0.8 bar (11.
7.
8. Installation Guidelines • • • • Make sure the appliance is fully intact and all fittings are complete. Make sure the power supply, grounding and cabling meet the specified requirements. Make sure the water pressure on the water supply line meets the specified requirements. Before installing and using the appliance, make sure there are no blockages in the water inlet or drain pipes. It is recommended to use stainless steel braided flex piping. Never solder the pipes or fittings.
1 2 3 4 Cable over sink installation Position the appliance upright with plumbing connections facing down. 1. Line up the Fixture disk and rubber pad. (Fig. 1) 2. Feed the faucet’s water pipe through the hole. (Fig. 2) 3. Line up the rubber pad and pedestal. (Fig. 3) 4. Feed the mounting element. (Fig. 4) Make sure the mounting elements are aligned. Then tighten the mounting nut and make sure the faucet is secure. 1 2 3 a) b) 5 120V 5.
Model COMFORTAP 1.8kW Make sure the faucet handle is in the OFF position. Then plug the electric cable into the power outlet.(Fig. 8b) 9. After completing the plumbing and electrical installation, and when operating the appliance for the first time, allow cold water to flow through the faucet for at least 20 seconds to flush the water line of any debris. After thoroughly flushing the line, you can complete the electrical installation. 8b 10.
11. Troubleshooting Problems No hot water comes out while the appliance is turn on. Outlet water temperature is too high. Outlet water temperature is too low. Possible causes No power. Water flow too slow. Corrective actions Verificati partea electrica si cablul de conectare Măriți debitul de apă Water flow too strong. Mesh screen filter on the water inlet may be clogged. Aerator may be clogged. Reduce water flow. Check and clean the mesh screen filter. Check and clean the aerator. 12.