Full Product Manual

General Installation Instructions
4
01
08 09
05
06 07
Install the shower head
heater higher than the
height of the user - not
less than 6½ft. (Figure 1)
Optional 1:
Connect the swivel ball joint to
the inlet (use Teon tape) before
installing the heater. (Figure 4)
Optional 2:
If necessary use
ֿ½״ NPT-½״ BSP Adaptor
(Figure 5)
After plumbing installation is
completed, carefully inspect the
connections for leaks.
Before proceeding to electrical
installation, run water through the
heater to ush out any air bubbles
from the system.
Connect the cable to a
dedicated circuit breaker
on the power distribution
panel. (Figure 3).
Install the heater around
12 inch from the wall and
ceiling. Use ½" Water pipe
(not supplied). (Figure 3)
Insert the lter to inlet
water unit. (Figure 2)
Make sure the unit is horizontally
level and stable, and the outow is
downwards.
To avoid leaks, use
Teon for all connections.
(Figure 3)
04
02 03