Hot Water on Demand Installation and Operation Guide TOP Electric Water Heater Shower Head 3.0kW/110V Instant water heater provides endless supply of hot water while significantly conserving energy and water www.atmorusa.
Important Safety Guidelines General description High quality and extremely reliable instant water heater. The TOP heater is the result of meticulous design based on years of experience and know-how. In this heater, 1 kW increases incoming water temperature by 50°F when water is flowing at a rate of 0.42 gpm. Easy to use heater. TOP requires no pre-heating or waiting time. The unit starts heating instantly as soon as the water tap is opened, and stops as soon as the tap is closed.
Technical Information Electrical Specifications Heating elements Watts Voltage Circuit Breaker Amperage Cable Size Plumbing Specifications 2 3,000 W 110 V 30 A Single Pole 10AWG (Line, Neutral, Ground) Minimum water flow to activate unit Working pressure Water connections 0.3 gpm 3.
General Installation Instructions 01 02 04 05 Optional 1: Connect the swivel ball joint to the inlet (use Teflon tape) before installing the heater. (Figure 4) 06 07 Make sure the unit is horizontally level and stable, and the outflow is downwards. Install the shower head heater higher than the height of the user - not less than 6½ft. (Figure 1) To avoid leaks, use Teflon for all connections.
1 2 12 inch 6 inch 78 inch 3 L N G Use Teflon tape 4 Use Teflon tape A Allen B Use key Swivel Ball joint Parts C 5 Use Teflon tape D Use Teflon tape E ½ ״NPT- ½ ״BSP Adaptor Use Teflon tape Use Teflon tape 5
Electrical Diagram 01 1 03 2 L1 N P 5 4 3 1. Switch (Option A): Off/On Switch (Option- B): Off/1/2/3 (1-Medium, 2- High, 3- Very high) 2. Heating element (Option A): 1 Heating element 3. Thermostat set to cut off at 135°F 4. Heating elements (Option- B): 2 Heating elements: Heating Position 1 – Medium Heating Position 2 – High Heating Position 3 – Very High 5.
Operation Guide •• This heater heats water based on flow rate. A lower flow rate produces hotter water. Water temperature can also be regulated by the Power settings (Off, Low, Medium, High). h) •• A pressure relief valve is located on the lower back side of the heater. The value is set to discharge if pressure exceeds 44 psi. To reset the valve, simply press the valve pin. F •• The spray holes must be cleaned if water is not flowing properly or sprays in the wrong direction.
LIMITED WARRANTY The terms of this warranty is solely subject to the original owner and is at no time transferable. A transfer of ownership will result in an immediate termination of this warranty. This warranty is valid only if product is purchased from an authorized reseller. Atmor warrants to the original owner that our instant water heaters will be free from defect in workmanship and material for a period of ONE YEAR from the date of purchase.
