Warranty

General Installation Instructions

06 07

Install the shower head

heater higher than the

height of the user - not

less than 6½ft. (Figure 1)

Optional 1:

Connect the swivel ball joint to

the inlet (use Teon tape) before

installing the heater. (Figure 4)

Optional 2:

If necessary use

ֿ½״ NPT-½״ BSP Adaptor

(Figure 5)

After plumbing installation is completed, carefully inspect

the connections for leaks.

Before proceeding to electrical installation, run water

through the heater to ush out any air bubbles from the

system.

Install the heater around

12 inch from the wall and

ceiling. Use ½" Water pipe

(not supplied). (Figure 3)

Insert the lter to inlet

water unit. (Figure 2)

Make sure the unit is horizontally

level and stable, and the outow is

downwards.

To avoid leaks, use

Teon for all connections.

(Figure 3)

02 03