User manual

Problem: I cannot communicate with other parties.

This is probably the most common error when setting encryption. Try one of the

suggestions below to solve your dilemma.

1. Make sure you and the other party is using the same encryption type, that

is, 64 bits or 128 bits.

2. Make sure the WEP key you are using matches the corresponding key the

other party (and access points if you are using any) is using and vice versa.

That is, if you are using Key 1, other parties value of Key 1

must be the

same as yours, and vice versa.

3. Make sure all parties are using the same authentication type. If uncertain,

set it to automatic.

If you are a Windows 98SE/2000/ME user and the other party is using Windows XP, then your key 1

have to match with their key 0, key 2 matches with key 1 and so on.