User Manual

14
Used in Run mode. Normal sensing of other keys not affected.
CAL of ‘k’ only takes place in the key’s normal timeslot.
Returns the ones compliment of the cmd char, once the cal is
scheduled.
-
~0xCk
12
Force calibration of key # k where k= 0..23.
Command must be repeated 2x consecutively
without any intervening command in 100ms to
execute
CAL key ‘k’
0xCk
14
Bits 7..5: reserved
Bit 4: 1= key is enabled
Bit 3: 1= key is in detect
Bit 2: 1= (Ref < LSL), even on a disabled key
Bit 1: 1= key is in calibration
Bit 0: 1= calibration of this key failed 5 times
Second return byte is CRC of cmmd + return data
Yes0..0xFF21Get status byte for key ‘k’ {0..23}Status for key ‘k’
0x8k
14
Diagnostic use only, not to be relied upon (no CRC). Signal and
ref are Tx as 2 bytes, LSB first.
-
0..0xFF
Each byte
51
Get signal, ref, Norm DI for key k {0..23}
Signal: 2 bytes; Ref: 2 bytes; Norm DI: 1
byte
Data for 1 key
0x4k
13
Returns 1’s compliment of last command even if bad. Resets the
communications error flag.
-0..0xFF11Returns last command received
Return last
cmmd
0x0F
13
CRC-8 only on Setups array section of eeprom
This CRC is the same as the CRC at the end of Setups block load.
Yes0..0xFF11Get eeprom CRCEeprom CRC
0x0E
13
100 block data bytes + 1 CRC byte returned.Yes
0..0xFF
Each byte
1001
Returns Setups block area followed by CRC.
Scanning is halted and then auto-restarted
after the cmd has completed.
Dump Setups
0x0D
Page
NotesCRCRtn range# Rtnd#/CmdDescriptionNameHex
lQ 17 QT60248-AS R4.02/0405