Datasheet

222
2586N–AVR–04/11
ATtiny25/45/85
– Table 20-16, “High-voltage Serial Programming Instruction Set for ATtiny25/45/85,”
on page 163
– Table 21-1, “DC Characteristics. T
A
= -40°C to +85°C,” on page 166, notes adjusted
– Table 21-11, “Serial Programming Characteristics, T
A
= -40°C to +85°C, V
CC
= 1.8 -
5.5V (Unless Otherwise Noted),” on page 175, added t
SLIV
– Bit syntax throughout the datasheet, e.g. from CS02:0 to CS0[2:0].
28.4 Rev. 2586K-01/08
1. Updated Document Template.
2. Added Sections:
– “Data Retention” on page 6
– “Low Level Interrupt” on page 51
– “Device Signature Imprint Table” on page 153
3. Updated Sections:
– “Internal PLL for Fast Peripheral Clock Generation - clkPCK” on page 24
– “System Clock and Clock Options” on page 23
– “Internal PLL in ATtiny15 Compatibility Mode” on page 24
– “Sleep Modes” on page 35
– “Software BOD Disable” on page 36
– “External Interrupts” on page 51
– “Timer/Counter1 in PWM Mode” on page 101
– “USI – Universal Serial Interface” on page 111
– “Temperature Measurement” on page 137
– “Reading Lock, Fuse and Signature Data from Software” on page 147
– “Program And Data Memory Lock Bits” on page 151
– “Fuse Bytes” on page 152
– “Signature Bytes” on page 154
– “Calibration Bytes” on page 154
– “System and Reset Characteristics” on page 170
4. Added Figures:
– “Reset Pin Output Voltage vs. Sink Current (V
CC
= 3V)” on page 189
– “Reset Pin Output Voltage vs. Sink Current (V
CC
= 5V)” on page 190
– “Reset Pin Output Voltage vs. Source Current (V
CC
= 3V)” on page 190
– “Reset Pin Output Voltage vs. Source Current (V
CC
= 5V)” on page 191
5. Updated Figure:
– “Reset Logic” on page 41
6. Updated Tables:
– “Start-up Times for Internal Calibrated RC Oscillator Clock” on page 28
– “Start-up Times for Internal Calibrated RC Oscillator Clock (in ATtiny15 Mode)” on
page 28
– “Start-up Times for the 128 kHz Internal Oscillator” on page 29
– “Compare Mode Select in PWM Mode” on page 89