User guide
Evaluation Kit Hardware
4-4 Evaluation Kit (EK) User Guide
11115A–ATARM–27-Jul-11
4.2.2.1 Devices
Following is the list of the CM board components:
One SAM9 Embedded MPU from the list below
– SAM9G15
– SAM9G25
– SAM9G35
– SAM9X25
– SAM9X35
12 MHz crystal
32.768 KHz crystal
1 Gbit DDR2 memory
2 Gits NAND Flash memory with Chip Selection control switch
32 Mbits SPI Serial DataFlash with Chip Selection control switch
512 Kbits EEPROM
1 Kbyte 1-Wire EEPROM
On-board power regulation
Two user LEDs
Optional PHY
4.2.2.2 Interface Connection
SODIMM200 card edge interface
4.2.2.3 Configuration Items
Dual ON/OFF switch for NAND Flash and SPI DataFlash Chip Select connection
Figure 4-2. CM Board Layout Commented
Sodimm200 card edge
SAM9 chip
NAND Flash
DDR2 SDRAM
PHY