User's Manual

3
Introduction
1.1. Scope:
The scope of this document is to explain how to install and setup up the required hardware and programming tool for
the certification test.
Figure 1 : Atmel ATSAMR30-XPRO Board
Hardware Setup
2.1. - 2 Nos
2.2. Micro USB cable - 2 Nos
Note: SMA cables not included in the box
Software Setup
3.1. Atmel Studio 7 (no need to install again if it is already available in Test PC)
3.2. Wireless Composer
3.3. Drivers - Installed automatically
3.4.
3.5.
ATSAMR30-XPRO Boards
ATSAMR30-XPRO
ATSAMR30-XPRO Performance Analyzer firmware flash-Install if required
ATSAMR30-XPRO Part Pack Intallation