User Manual
Table Of Contents
- Preface
- Table of Contents
- 1. Introduction
- 2. Getting Started
- 3. Xplained Pro
- 4. Hardware User Guide
- 5. Kit Specific Data
- 6. Agency Certification
- 7. Hardware Revision History and Known Issues
- 8. Document revision history
- 9. Evaluation Board/Kit Important Notice
Atmel SAM R21 Xplained Pro [USER GUIDE]
42243B-MCU-06/2014
18
Important
The 'CE' marking must be affixed to a visible location on the OEM product. The CE mark shall
consist of the initials "CE" taking the following form:
● The CE marking must have a height of at least 5mm except where this is not possible on
account of the nature of the apparatus.
● The CE marking must be affixed visibly, legibly, and indelibly.
More detailed information about CE marking requirements you can find at "DIRECTIVE 1999/5/
EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL" on 9 March 1999 at section 12.
6.3 Canada (IC)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with radio frequency exposure limits set forth by Industry Canada for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between the
device and the user or bystanders.
Cet équipement est conforme aux limites d'exposition aux radiofréquences définies par Industrie Canada
pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20cm de
distance entre le dispositif et l'utilisateur ou des tiers
Important
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
6.4 List of Antennas Tested With This Product
Table 6-1. List of Tested Antennas
Antenna Number Make Model/Part # Antenna Gain
(dBi)
Type of Antenna
Antenna 1 Johanson
Technology
2450AT18D0100 1.5dBi Ceramic Antenna
Antenna 2 Techfun Co., Ltd M01-SS2 0dBi External Antenna
Important
If professional users including, but not limited to Research and Development engineers wants to
configure the power settings higher than those specified in page 7 of the FCC test report number
19660076 001, they are advised to use the antenna / device only in a shielded room.