User Manual
ATZB-S1-256-3-0-C ZigBit 2.4GHz Single chip Wireless Module [DATASHEET]
42191AWIRELESS10/2013
8
3. Specifications
3.1 Electrical Characteristics
3.1.1 Absolute Maximum Ratings
Table 3-1. Absolute maximum ratings
(1)(2)
.
Parameter
Minimum
Maximum
Voltage on any pin, except RESET with respect to ground
-0.3V
3.6V (V
DD
max
)
Input RF level
+14dBm
Voltage on any Analog configured pin
-0.3V
2.0V
Voltage on Aref (pin 24)
-0.3V
2.0V
Notes: 1. Absolute Maximum Ratings are the values beyond which damage to the device may occur. Under no
circumstances must the absolute maximum ratings given in this table be violated. Stresses beyond those
listed under "Absolute Maximum Ratings" may cause permanent damage to the device.
This is a stress rating only. Functional operation of the device at these or other conditions, beyond those
indicated in the operational sections of this specification, is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
a) Attention! The ZigBit is an ESD-sensitive device. Precaution should be taken when handling the device
in order to prevent permanent damage.
3.1.2 Power Supply
Table 3-2. Test conditions (unless otherwise stated), F = 2.45GHz, V
DD
= 3V, T
amb
= 25°C.
Parameter
Range
Unit
Supply voltage, V
DD
1.8 to 3.6
V
Active Current consumption: RX mode
- RX_ON – Listening state
17.0
mA
Active Current consumption: TX mode
(1)
– BUSY_TX – Transmit state
16.3
mA
Active Current consumption: TX mode
– PLL_ON
9.9
mA
Active Current consumption: TRX_OFF
4.7
mA
Sleep Current consumption: Power-save mode
(2)
0.62
µA
Sleep Current consumption: Power-down mode
(2)
0.6
µA
Sleep Current consumption: Standby
(2)
2.4
mA
Sleep Current consumption: Idle
(2)
4.9
mA
Sleep Current consumption: Ext_Standby
(2)
0.9
mA
Note 1:
a) Output TX power (when measuring consumption in TX mode) is +3 dBm.
Note 2:
a) All interfaces are set to the default state (see Pin Assignment Table).
b) JTAG is not connected.
c) CPU Clock configured when doing this measurement – 16MHz for all modes except Power save and Power down
modes