User Manual
Atmel AT03911: REB233CBB Module – User Manual [APPLICATION NOTE]
42156BWIRELESS02/2014
14
Warning: IMPORTANT FCC NOTICE to USERS
Changes or modifications not expressly approved by this company could void the user’s authority to operate the
equipment.
B.2 Europe (ETSI)
If the device is incorporated into a product, the manufacturer must ensure compliance of the final product to the
European harmonized EMC and low-voltage/safety standards. A Declaration of Conformity must be issued for each of
these standards and kept on file as described in Annex II of the R&TTE Directive.
The manufacturer must maintain a copy of the device documentation and ensure the final product does not exceed the
specified power ratings, and/or installation requirements as specified in the user manual. If any of these specifications
are exceeded in the final product, a submission must be made to a notified body for compliance testing to all required
standards. The “CE“ marking must be affixed to a visible location on the OEM product. The CE mark shall consist of the
initials "CE" taking the following form:
If the CE marking is reduced or enlarged, the proportions given in the above graduated drawing must be
respected
The CE marking must have a height of at least 5mm except where this is not possible on account of the nature
of the apparatus
The CE marking must be affixed visibly, legibly, and indelibly
More detailed information about CE marking requirements you can find at "DIRECTIVE 1999/5/EC OF THE
EUROPEAN PARLIAMENT AND OF THE COUNCIL" on 9 March 1999 at section 12.
B.3 Approved antenna
The device has been tested and approved for use with the antenna type listed below. The device may be integrated
with other custom design antennas which OEM installer must authorize with respective regulatory agencies. The used
antenna is to be connected to the Radio PCB via an SMA connection.
Table 8-5. Approved antenna.
Manufacturer
Description
Model
Frequency
Connector
TEKFUN Co.
¼-wave swivel SMA Male
antenna
M35-S
2400MHz
Male SMA