Owner's Manual

Active Thermal Management Cool-slim Component Cooler Page 1 of 2

Active Thermal Management

The trusted name in thermal protection

Instructions for installation of the Cool-slim Component Cooler

Product Description -- The Cool-slim Component Cooler is placed on top of a hot

component and will cool it quietly. Some types of audio-video equipment have ventilation

openings on their top surface while others do not; Cool-slim can cool either type. Hot air is drawn

from the component and exhausted through its front

and rear openings.

NOTE - The Cool-slim Component Cooler was designed to cool

components in an open, or partially open, environment such as on a

shelf, in a bookcase, or in a cabinet with no doors and/or an open back.

It cannot cool components in sealed enclosures; it would just circulate

the same hot air within the enclosure, providing little cooling. Active

Thermal Management offers a complete line of cooling equipment

designed to cool entire enclosures, from the smallest to the largest, at

www.activethermal.com.

Connections & Operation

Cooling components with top openings –

Center the Cool-slim directly over the openings on the component.

Figure 1

PAGE 1
Active Thermal Management The trusted name in thermal protection Instructions for installation of the Cool-slim Component Cooler Product Description -- The Cool-slim Component Cooler is placed on top of a hot component and will cool it quietly. Some types of audio-video equipment have ventilation openings on their top surface while others do not; Cool-slim can cool either type. Hot air is drawn from the component and exhausted through its front and rear openings.
PAGE 2
Cooling components without top openings – Center the Cool-slim over the hottest area on the component being cooled. It will pull cool room air over and along the top of the component, removing much of the heat being generated. All components – Place the probe where it can sense the heat coming from the component to be cooled (frequently this will be under or beside the Cool-slim). Plug the probe’s cable into the right-hand jack on the rear panel, and the power supply cable into the left-hand jack.