Owner's Manual
Figure
1-
Base mode fan mounting Figure 2 - Shelf mode fan mounting
To change from "Base" to "Shelf'' mode
of
operation:
Remove the four screws
and
nuts holding
one
fan
to the
top
surface and turn the fan
over
so
that
the
ATM
logo faces
DOWN.
Put
the screws,
one
at
a time, through the cover
plate, top surface, spacer, and fan flange as
in
Figure 2. Leave all screws somewhat loose
until all are installed, and then tighten all four moderately;
do
not
over
tighten. Repeat
for
the second fan.
When finished, each fan will be attached
as
in
Figure
2,
and
the cover plates will
be
in
place.
25570 Rye
Canyon
Rd.
(661) 294-7999 voice
W\vw.acti vethermal .com
..
Valencia, California 91355
(661) 294-1115
fax
Page 4
of
4