Owner's Manual
For your convenience, here are some commonly-used Fahrenheit temperatures and their Celsius
equivalents, rounded to
the
nearest whole degree.
75F = 24C
85F = 29C
95F = 35C
80F-
27C
90F = 32C
lOOF
= 38C
"'Pressing the ~ or ,.- buttons again will cycle the display through the following codes:
Pl
, P2,
P3, P4,
PS
, P6, and back
to
PO
. Many
of
these codes refer to parameters used
in
heating and
refrigeration systems, not in cooling systems. Should any be adjusted accidentally, restore them to
their factory settings:
PO
- C (for
"coo
ling
")
Pl
- Desired differential, set as described above
P2 -
11
0
P3 - -50
P4-
0
PS
- 0
P6
-0ff
To
change from "Shelf'' to "Base" mode
of
operation:
Using a Philips screwdriver, unscrew and remove the four long screws, spacers, and nuts
holding one
of
the fans and the plate covering the hole in the top surface
of
the Dual-
Mode Component Cooler. Set the cover plates and spacers aside for possible future use.
Turn the fan over so that the ATM logo, which faces
DOWN
in
Shelf
mode, faces UP,
and insert the four long screws, one at a time, through the top surface and both holes
in
one corner
of
the fan. Leave the screws somewhat loose until all four are installed, and
then tighten all four moderately; do not over tighten. Repeat for the second fan.
When finished, each fan will be attached as in Figure 1, and the ATM logo in the center
of
the fan will be visible through the top surface
of
the Dual-Mode Component Cooler.