Owner's Manual
Connections & Operation
After mounting the fans, select the location
for
the fan
controller. It has 2 magnets
on
its flanges, allowing it to
adhere to most audio-video components.
Run
the fan wires
to the controller, and plug them onto the connectors
FAN
l
or
FAN
2.
Plug
the thermal
probe's
cable onto the
connector
THRM
on the controller. Plug the
power
supply
into an
AC
outlet that is always live, and plug the power
supply's output lead into JI
on
the controller.
The
green
led should light. When the
probe's
temperature-sensitive
tip reaches approximately 88-90 degrees, the fans will
begin to turn
and
the red led will light. Use a hair dryer to
test the system; do
NOT
use an open flame
or
heat-shrink
gun.
Note-
When
cooling
modem
home theater systems, the fans may run continuously. Cable boxes, satellite
receivers, some whole-house amplifiers and digital program recorders run continuously.
Their
heat
may
be
enough to keep the Cool-vent fans in operation. The Cool-vents, like all A
TM
products, are
designed to operate continuously, drawing only a few watts
of
electrical
power
while keeping
temperatures
low
in an enclosure.
25570 Rye Canyon Rd.
(661) 294-7999 voice
techinfo(@acti vethermal .com
Valencia, California 91355
(661) 294-1115 fax
W\V\V
.activethermal.com