Owner's Manual

tBHHH
Active Thermal Management
The trusted name in thermal protection
Cool-vent 11-E & III-E Installation Instructions
The Cool-vents are compact self-contained air moving devices for use in enclosures housing
heat-producing equipment. They can easily be field-modified to work in either intake or
exhaust mode. If used as an intake device, provisions must be made to allow the escape of
hot air; similarly, when used in exhaust mode, there must be an opening through which room
air can enter.
Cool-vents are powered by a plug-type power supply and are controlled by a thermal probe
connected to a small module, switching on at 90 degrees. They mount on a finished surface
through cutouts shown in the accompanying chart. The fan assembly is easily separated from
the wood grille to allow finishing the grille without damaging the fans.
Model
Rough opening
Cool-vent II
Cool-vent III
61/s" X 141/s"
Finished size
5 ½" X 15 ½"
7¼"x15½"
Number/size of
fans
4180mm
21120mm
As shipped, Cool-vents are assembled as an intake device; air is pulled from the grille side
through the fans.
When the fan and grille sections are reattached, the Cool-vent can be assembled to operate in
either intake or exhaust mode.
□ In intake mode, it can be mounted low on a cabinet to bring room air in.
□ In exhaust mode, it can be mounted above or behind an amplifier or another heat-
producing component to expel heated air.
Main installation steps:
25570 Rye Canyon Rd.
[phone] voice
techinfo(@acti vethermal. com
Valencia, California 91355
( 661) 294-1115 fax
WVvW .activethermal.com