Owner's Manual
Connections & Operation
After mounting the fans, select the location for the fan
controller. It has 2 magnets on its flanges, allowing it to
adhere to most audio-video components.
Run
the fan wires
to the controller, and plug them onto the connectors
FAN
I and FAN
2.
Plug the thermal probe's cable onto the
connector THRM on the controller. Plug the power supply
into an AC outlet that is always live, and plug the power
supply's output lead into
JI
on the controller. The green
led should light. When the probe' s temperature-sensitive
tip reaches approximately 88-90 degrees, the fans will
begin to turn and the red led will light. Use a hair dryer to
test the system~ do NOT use an open flame
or
heat-shrink
gun.
Thermal probe Fan I
Fan
2
Choose a permanent location for the thermal probe. It can be located on the component that generates the most
heat when on, or in the air near the top
of
the enclosure
if
no one component generates a large amount
of
heat,
but together they raise the temperature
of
the enclosure significantly. Peel the paper backing
off
the anchor and
press it against the mounting
surf
ace for a few seconds.
Note -
When cooling modem home theater systems, the fans may run continuously. Cable boxes, satellite receivers,
some whole-house amplifiers and digital program recorders run continuously. Their heat may be enough to keep
the System 3 fans in operation. The System 3, like all
ATM
products, is designed to operate continuously,
drawing only a few watts
of
electrical power while keeping temperatures low in an enclosure.
Warranty
Active Thermal Management (
..
ATM") warrants the System 3 against defects in materials and workmanship for
a period
of
one year from date
of
purchase.
We
will repair or replace, at our option, any System 3 which has a
defect in materials or workmanship. The product being returned must be properly packaged and returned
prepaid with an ATM return authorization number clearly written on the outside
of
the shipping carton and with
a copy
of
the bill
of
sale or A
TM
invoice to verify the original purchase date.
Our warranty does NOT apply to:
1. Shipping damage, either concealed or visible. Claims must be filed with the carrier.
2.
Damage caused
by
improper installation
or
improper electrical voltage.
3.
Any System 3 which has been modified.
25570 Rye Canyon Rd. Suite D
661-294-7999 (voice)
tech infor@activethermal.com
Valencia, CA 91355
661-294-1115 (fax)
www
.activethermal.com