Application Programming Interface
AT-OME-ST31A
3
Commands
Command Description
Blink Enables or disables blinking of the POWER button on the front panel
CommaWait Enables or disables a comma adding a 5 second delay between commands
DispBtn Simulates pressing the DISPLAY button on the front panel
help Displays a list of available help commands
InputStatus Displays the status for each input
IP802.1x Sets the security authentication type
IPCFG Displays IP address conguration
IPDHCP Turns DHCP on / o
IPStatic Sets a static IP address
Lock Locks the buttons on the front panel
LRAUD Mutes the audio on the analog output
Mreset Sets the unit back to default settings
PWOFF Execute this command to power-o the unit
PWON Execute this command to power-on the unit
PWSTA Displays the power state of the unit
RepCmdTime Sets the number of times a command is repeated
RepeatCmd Enables or disabled the RepCmdTime feature
RHostName Displays the host name for the AT-OME-ST31A
RS232zone Triggers the unit to send the RS-232 command to the display connected to the
HDBaseT receiver’s RS-232 port
SHostName Sets the host name for the unit
Status Displays the routing state of the unit
Type Displays the model of the unit
Unlock Unlocks the buttons on the front panel
Version Displays the current rmware version of the unit
VOUTMute Mutes the output volume for the specied output
xY$ Mutes/Unmutes AV signals for the specied output channel
xYAVxZ Switches the specied input to the specied output
IMPORTANT: Each command is terminated with a carriage-return (0x0d) and the feedback is
terminated with a carriage-return and line-feed (0x0a).
The following tables provide an alphabetical list of commands available for AT-OME-ST31A. Commands are case-
sensitive. If the command fails or is entered incorrectly, then the feedback is “Command FAILED”. Commands can
be sent using RS-232 or Telnet. There should be a 500 millisecond delay between each command sent to the unit.
The default port for Telnet is 23.