Manual

AT-HDVS-200-TX-WP / AT-HDVS-200-TX-WP-BLK
38
Command Description
DispKeyLock Locks or unlocks the DISPLAY button on the front panel
Display Send the command to the display device using the current protocol
DispRS Sets the display command type to RS-232
FreeRun Enables or disables “audio-only” from the transmitter to the receiver
HDCPSet Sets the HDCP reporting mode for the HDMI IN 1 port
HDMIAUD Enables or disables audio on the HDMI output
HDVS Displays the model number of the connected receiver
help Displays the list of available commands
HUE Sets the picture hue
Input Sets the active input
IPAddUser Adds a user for Telnet control
IPCFG Displays the current network settings for the AT-HDVS-200-TX-WP
IPDelUser Deletes the specied Telnet user
IPDHCP Enables or disables DHCP mode on the AT-HDVS-200-TX-WP
IPLogin Enables or disables login credentials when starting a Telnet session
IPPort Sets the Telnet listening port for the AT-HDVS-200-TX-WP
IPStatic Sets the static IP address, subnet mask, and gateway for the AT-HDVS-200-TX-
WP
IPTimeout Species the time interval of inactivity before the Telnet session is closed
LRAUD Enables or disables audio on the L/R analog output
Mreset Resets the AT-HDVS-200-TX-WP to factory-default settings
PictureRst Resets all picture settings
PrefTimg Sets the preferred HDMI input timing
ProjSWMode Sets the cool-down intervale of the projector
ProjWarmUpT Sets the projector warm-up time interval
RS232para Sets the baud rate, data bits, stop bits, and parity for the RS-232 port
RS232zone Send a command to the HDBT device
RxRSparaZ Species the RS-232 settings for the RS-232 1 port on the receiver
SATRT Sets the picture color saturation
SetCmd Assigns an RS-232 or IP command to the specied button on the front panel
Commands