Manual

AT-HDVS-200-TX-WP / AT-HDVS-200-TX-WP-BLK

The AT-HDVS-200-TX-WP includes a built-in web GUI. Atlona recommends that the web GUI be used to set up the

AT-HDVS-200-TX-WP, as it provides intuitive management of all features.

The AT-HDVS-200-TX-WP is shipped with DHCP enabled. Once connected to a network, the DHCP server will

automatically assign an IP address to the unit. Use an IP scanner to determine the IP address of the AT-HDVS-200-

TX-WP. If a static IP address is desired, refer to IP Conguration (page 13). The default static IP address of the

AT-HDVS-200-TX-WP is 192.168.1.254.

Introduction to the Web GUI

1. Launch a web browser.

2. Use one of the following methods to access the IP address of the AT-HDVS-200-TX-WP:

a. Login to the web GUI of the receiver unit that is connected to the AT-HDVS-200-TX-WP. Once logged in,

click the link for the AT-HDVS-200-TX-WP, as shown:

b. Use an IP scanner to locate the IP address of the AT-HDVS-200-TX-WP on the network. The MAC address,

on the back of the unit, can be used to identify the unit with the IP address.

3. The Login page for the receiver will be displayed.

The Web GUI

NOTE: The web GUI can only be accessed if the AT-HDVS-200-TX-WP is connected to a compatible

PoE receiver unit, such as the AT-HDVS-200-RX, using the HDBaseT port. The receiver must be

connected to the network.