Manual

AT-HDVS-200-TX-WP / AT-HDVS-200-TX-WP-BLK

Installation

3. Execute the IPStatic command. This command requires three arguments: the desired IP address of the

AT-HDVS-200-TX-WP, the subnet mask, and the gateway address. All arguments must be entered in dot-

decimal notation. The following is an example:

IPStatic 192.168.1.112 255.255.255.0 192.168.1.1

• Setting DHCP mode

1. Connect to the AT-HDVS-200-TX-WP using RS-232 or Telnet.

2. At the command line, execute the IPDHCP command using the on argument, as shown. All characters are

case-sensitive.

IPDHCP on

Once DHCP is enabled, the unit will be assigned an IP address by the DHCP server (if present).

Using the Web GUI

The System page (page 31), in the web GUI, allows the AT-HDVS-200-TX-WP to use either DHCP or static IP

mode. In order to access the web GUI, the IP address of the AT-HDVS-200-TX-WP must be known.

1. Open the desired web browser and enter the IP address of the AT-HDVS-200-TX-WP.

2. Log in, using the required credentials. The factory-default username and password are listed below:

Username: root

Password: Atlona

3. Click the System tab.