Manual

AT-HDVS-200-TX-WP / AT-HDVS-200-TX-WP-BLK
13
RS-232
RXTX
DISPLAY
AUDIO IN
VGA IN
HDMI IN
PWR
LINK
VOL-
INPUT
VOL+
FW
RS-232
RXTX
DISPLAY
AUDIO IN
VGA IN
HDMI IN
PWR
LINK
VOL-
INPUT
VOL+
FW
Installation
IP Conguration
The AT-HDVS-200-TX-WP is shipped with DHCP enabled. Once connected to a network, the DHCP server (if
available), will automatically assign an IP address to the unit. Use an IP scanner, along with the MAC address on the
back the unit, to identify both the unit and its IP address on the network. If a static IP address is desired, the unit can
be switched to static IP mode. Use one of the following procedures to switch between DHCP and static IP mode.
The default static IP address of the AT-HDVS-200-TX-WP is 192.168.1.254.
Using the Front Panel
1. Make sure the AT-HDVS-200-TX-WP is powered, by connecting it to a PoE-compatible receiver, such as the AT-
HDVS-200-RX. Both power and IP control is carried over the HDBaseT port.
2. Press and hold the INPUT button for approximately 15 seconds.
3. Release the INPUT button once the PWR LED indicator begins to ash. The number of ashes will indicate the
currently selected IP mode.
PWR LED indicator
HDBaseT port
PW LED ashes Description
Two Static IP mode
Four DHCP mode
Use the IPStatic and IPDHCP commands to switch between DHCP and IP mode through RS-232 or Telnet. Refer to
Commands (page 37), for more information. All commands and their arguments are case-sensitive.
Using Commands
• Setting static IP mode
1. Connect to the AT-HDVS-200-TX-WP using RS-232 or Telnet.
2. At the command line, execute the IPDHCP command using the o argument, as shown.
IPDHCP o