Datasheet

I
2
C mode
To set your EZO
TM
device into I
2
C mode click here
The I
2
C protocol is considerably more complex than the UART
(RS–232) protocol. Atlas Scientific assumes the embedded
systems engineer understands this protocol.
r 0.1
Settings that are retained if power is cut
Calibration
Change I
2
C address
Hardware switch to UART mode
LED control
Protocol lock
Software switch to UART mode
Sleep mode
Settings that are NOT retained if power is cut
Settings that are retained if power is cut
Baud rate
Calibration
Continuous mode
Device name
Enable/disable response codes
Hardware switch to I
2
C mode
LED control
Protocol lock
Software switch to I
2
C mode
Sleep mode
Settings that are NOT retained if power is cut