Data Sheet

command quick reference
UART mode
Command Default stateFunction
All commands are ASCII strings or single ASCII characters.
change baud rate 9,600Baud pg. 35
enable/disable continuous reading enabledC pg. 22
performs calibration n/aCal pg. 24
enable factory reset n/aFactory pg. 37
device information n/ai pg. 31
change to I
2
C mode not setI2C pg. 38
enable/disable LED enabledL pg. 20
set/show name of device not setName pg. 30
enable/disable parameters mg/LO pg. 29
pressure compensation 101.3 kPaP pg. 28
enable/disable protocol lock disabledPlock pg. 36
returns a single reading n/aR pg. 23
salinity compensation n/aS pg. 27
temperature compensation 20˚CT pg. 26
enter sleep mode/low power n/aSleep pg. 34
retrieve status information n/aStatus pg. 33
enable/disable response codes enable*OK pg. 32
nds device with blinking white LED n/aFind pg. 21
export/import calibration n/aExport/import pg. 25