Instructions / Assembly

4
Before touching a screw driver thoroughly
read these installation instructions.
Your new wall fan will require a grounded
electrical supply line of 120 volts AC, 60 Hz
circuit. The junction box must be securely
anchored and capable of withstanding a load
of at least 45 lbs.
WARNING/CAUTION: Before installing new
wall junction box turn off power at service
panel.
1. Attach junction box securely to building
structure. Use provided hardware. Caution:
Tighten screws well. (See Figure 1)
WARNING/CAUTION: To avoid possible
electrical shock, be sure that electricity to the
wall junction box and to the wall switch is
turned off at the main fuse box before wiring.
2. Verify that the set screws in decorative
canopy are fully retracted. Not retracting them
will cause unsightly scratches in the beautiful
finish of the goose neck during installation.
Leave the protective plastic sleeves in place
on the gooseneck of the fan. Carefully push
wires through the canopy and then slide the
canopy up the gooseneck to the bend with
wide section positioned towards wall (Fig. 2).
3. Thread wires through the barrel of the
hanger bracket, pulling them taut at the flat
end. Attach hanger bracket to the goose neck
carefully, aligning the x4 Allen screw holes.
Tighten the x4 Allen screws well.
MOUNTING/INSTALLLATION
OF THE FAN AND MAKING
THE ELECTRICAL
CONNECTIONS
Figure 1
Side mount
wall junction box
Screws
Figure 2
Hanger
bracket
Canopy
Screws
Allen wrench