Owner`s manual

Owner’s Manual
F6-AMIX
Multi-Function Analog Mixer Card
AtlasSound.com – 7 –
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
8. Mic/Line VCA - Connect an external 10KΩ potentiometer (Atlas AAVC-10K) to these two
terminals
to remotely control the level of the Mic/Line input signal. Note: This feature operates as an
attenuator only. It is recommended that prior to installing the external pot, set the maximum levels
first. Placement of remote level can be up to 200ft away from the F6 amplifier. Suggested wire size
is 20-22 gauge. Audio is present on these wires.
9. Aux VCA - Connect an external 10KΩ potentiometer (Atlas AAVC-10K) to these two terminals to
remotely control the level of the RCA input signal. Note: This feature operates as an attenuator
only.
It is recommended that prior to installing the external pot, set the maximum levels first. Placement
of remote level can be up to 200ft away from the F6 amplifier. Suggested wire size is 20-22 gauge.
Audio is not present on these wires.
10. Dip Switch One Function Selection
• Switch 1 RCA to Channel One Bus
• Switch 2 RCA to Channel Two Bus
• Switch 3 RCA to Channel Three Bus
• Switch 4 RCA to Channel Four Bus
• Switch 5 RCA to Channel Five Bus
• Switch 6 RCA to Channel Six Bus
• Switch 7 Mic/Line to Channel One Bus
• Switch 8 Mic/Line to Channel Two Bus
• Switch 9 Mic/Line to Channel Three Bus
• Switch 10 Mic/Line to Channel Four Bus
• Switch 11 Mic/Line to Channel Five Bus
• Switch 12 Mic/Line to Channel Six Bus
11. Dip Switch Two Function Selection
• Switch 1 NC (Not Used)
• Switch 2 Line (Up Position) Mic (Down Position)
• Switch 3 Mic Phantom 15VDC (Down Position is ON)
• Switch 4 Mute Receive Channel One
• Switch 5 Mute Receive Channel Two
• Switch 6 Mute Receive Channel Three
• Switch 7 Mute Receive Channel Four
• Switch 8 Mute Receive Channel Five
• Switch 9 Mute Receive Channel Six
• Switch 10 Mute Receive RCA Input