Owner`s manual

– 11 – AtlasSound.com
Specifications are subject to change without notice.
Owner’s Manual
F6-MF
Multi-Impedance Modular Amplifier
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
FM250 Amplifier Module Installation
Use the following steps and read all steps prior to installation.
1. Turn F6-MF AC Power Switch to the “Off” position.
2. Turn down all level controls on the front panel.
3. Remove the blank card slot cover. Do not discard the two screws, you will need them later.
4. Set the function switches on the FM250 module. (See Page 10)
 5. CarefullyandslowlyguidethemoduleintotheslotwiththePCBcomponentsfacingtotheright.Note: The module heatsink
top and bottom metal edge mate with the mainframe plastic card guides. Do not force the card. Realign if necessary.
 6. AfterthemoduleispushedinandincontactwiththebackplaneofthePCBassemblymatingconnector,firmlypressthe
module in completing the connection. If the module plate is flush to the F6-MF, the module is fully seated.
7. Insert the two screws from the cover pate. Some minor alignment may be required.
Align Modules to
Top & Bottom Card
Guides