Owner`s manual

AtlasSound.com – 8 –
Specifications are subject to change without notice.
Owner’s Manual
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
EMMA2K-B Line Array System
Installation Instructions - Two People Recommended
1. Stand the EMW410A upright and locate it’s position in the venue. Install the stabilizer bar in the bottom rear of the cabinet. Attach
the bar with the thumbscrews and stabilize the cabinet with the outriggers.
2. Set the EM806A-B cabinet in front of the EMW410A-B. With two people standing facing each other with the EM806A-B cabinet
between them, grab the lower handle and lean the top forward keeping one other hand on the face of the cabinet. Lift cabinet in a
horizontal fashion and then stand it vertical as you lift into position and inser the feet of the EM806A into the recesses on the top
of the EMW410A cabinet and stand it up vertical.
3. Insert the EMMA wrench into the lower side of the EM806A-B and rotate the wrench forward and lock the cam arms into the
receivers of the EMW410A. Note: to ensure cam is in the correct position, rotate wrench opposite way to set it and then making
sure the cam arm is fully extended and latches into the EMW410A cabinet. Turn until completely locked in place.
4. Once the EM806A-B cabinet is securely attached to the EMW410A-B, readjust the stabilizer outriggers to ensure stability.
Note: The vertical coverage of the EM806A is +/- 5° off the top and bottom of the cabinet. The stabilizing bar may need to be
adjusted to tilt the unit forward, but no more than 2 degrees, to keep the array energy off of back walls or to cover audience.
5. System Wiring
Audio Signal - Use a balanced XLR cable for main signal and plug it into the amplifier on the EMW410A-B labeled , “Input”, and
then using the XLR cable provided, connect it to the EM806A-B input using the “Looping Output”.
A/C Power - Connect the main power cable, Eddison to Powercon, to the blue Neutrik connector on the amplifier panel of the
EMW410A-B. Using the A/C cable provided, jump from the A/C out grey “Power Output” connector on the EMW410A-B cabinet to
the blue connector on the EM806A-B amplifier.
6. Turn on the amplifiers and adjust volume as needed.
7. The system can be dismantled follwing the previous steps in reverse order to ensure proper disconnection and future functionality.