Owner`s manual

AtlasSound.com – 14 –
Specifications are subject to change without notice.
Owner’s Manual
DSP2210 &
DSP2212
Digital Processor
and Amplifier
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
SPECIFICATIONS
SYSTEM PERFORMANCE / DSP PROCESSORS
• Dynamic range >102dB A-weighted
• Frequency response 80Hz – 20kHz ± 3dB at rated output
• Distortion THD+N .001% typical at +4dBu, 1kHz, 0dB gain
• Input sensitivity 2Vrms Max 20KΩ
• Interchannel crosstalk > 80dB typical
• Crosstalk input to output > 80dB
• Channel separation > 100dB at 1kHz (in thru out)
• Common mode rejection
ration (CMRR) > 50dB, 20Hz – 20kHz typical > 55dB at 1kHz
• Processor capacity Fixed Point, Audio Specific
• Sample rate audio conversion 48kHz
• D/A converter type (Audio) 24-bit Sigma Delta
• D/A performance dynamic
range (converter) > 100dB A-weighted
• A/D performance dynamic range > 110dB A-weighted
• Non-volatile memory Memory storage for all programs and set up protected for (24) hours in power brown out,
interruption or computer shut down. Data settings good for (10) years w/o refresh
• CODEC – DSP protection All I/O protected with buffers from spikes and transients or sneak currents
SYSTEM INPUTS (unless noted located on rear panel)
• Power AC Mains IEC 3-pin with ground, 80-240VAC, 50-60HZ
• Network (DSP2212 only) RJ45 module jack (EIA 568B)
• Microphone 3-pin dockable keyed connector
• Background Music RCA connector 10K Ohm (sum to mono)
SYSTEM OUTPUTS (unless noted located on rear panel)
• Zone Speakers 2-pin dockable keyed connector (70V @ 25W RMS)
• Network system link RJ45 modular jack (EIA 568B) [unit #2 - #32]