Owner`s manual

– 9 – AtlasSound.com
Specifications are subject to change without notice.
Owner’s Manual
AP-S20RT
AC Distribution & Suppressor Unit
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Installation
Beforeinstalling,itisrecommendedtoreadtheentiremanualtoensureproperoperationandthatallfeaturesarebeingutilized.The
AP-S20RT can be placed on a shelf or rack mounted in a standard 19" width rack. When rack mounted, placement within the rack is
exiblehowevertheAP-S20RTshouldbewithin6'ofadedicated20AACoutlet.Whenrackmounting,useRackRailtypescrewsof
10
⁄32"x1".Alwaysmakesurethe20AoutletisproperlyinspectedbyacertiedelectricianpriortoconnectingtheAP-S20RT.Makesureto
inspect the equipment that will be connected to the AP-S20RT to ensure it does not exceed 20A total amperage draw.
Remote Activation Connections Diagram
Remote Activation via Hard Contact Switch
UseExternalKeyorPanelSwitch,HardContact
ToRemotePanelLED,Usethe+12andGNDTerminals.
Note: Use a 2K ohm
1
⁄8WResistorInSerieswith+12VDCandLED
RemoteVoltageActivation
Apply+5V–24VDCandConnectaGroundtotheGNDTerminal
to Activate the Unit.
Note: It is OK to Have Two Wires In the Same Terminal.
ToRemotePanelLED,Usethe+12andGNDTerminals.
Note: Use a 2K ohm
1
⁄8WResistorInSerieswith+12VDCandLED