Roofing System Warranty

printed instructions on the product bundle wrappers.
b. Damage to the products caused by inadequate attic/roof sheathing ventilation (Note: Ventilation must
meet the FHA and HUD Minimum Property Standards or a minimum of one (1) square foot of net free attic
vent area for every 150 feet of attic oor area; or one square foot per every 300 square feet, if vapor barrier is
installed on the warm side of the ceiling, or at least one half the ventilation area is provided near the ridge.
c. The use of any self-described metallized or metal containing category of “Radiant Barrier,” as an asphalt
shingle underlayment installed above the deck. Spray-on types of below-deck vapor permeable radiant
barriers will be considered only on a job-by-job basis, and only if tested conrmed greater than 2 perms and
adequate ventilation can be achieved.
d. Replacement of products for the rst six (6) months after application due to:
1. Loss of Granules: Products when rst applied will have some excess granule wash o.
2. Discoloration: i) Some color shading may occur due to positioning or embedment of the granule; ii)
Yellow staining and/or powder-like shading may occur due to transfer of backing materials.
The conditions listed in section (c) are normal and should be eliminated by natural weathering conditions
over a six (6) month period after application.
e. Damage to a roof due to settlement, distortion, failure or cracking of the roof deck, walls or foundation of a
building or to any defect in or failure of material used as a roof base over which products are applied or for
damage by foot trac on the roof.
f. Damage from any cause other than inherent manufacturing defect.
g. Acts of God including lightning, wind gusts in excess of the specied Wind Speed Limits listed
herein, hurricane, tornado, hailstorm, impact of foreign objects, or other violent storms.
h. We are not liable to you if you make a warranty claim in the future, or make structural changes and any
replacement shingles vary in color either due to normal weathering or changes in our product line or color blend.
i. Claims by owners or transferees not qualifying as Original Owners or Authorized Transferees under
this Limited Warranty.
j. Black streaks due to blue-green algae growth where shingles were installed on a low slope
roof, i.e. installations with a slope that is less than or equal to 2/12”; installations in which
non-Atlas Shingles with Scotchgard (including, without limitation, low slope roong and low
slope roong draining onto mansard roong) shed water onto Atlas Shingles with Scotchgard;
Roong installations where Atlas Shingles with Scotchgard do not comprise the entire shingled
area of the roof, including, without limitation, hip and ridge shingles.
k. Roong installations where discoloration of the shingles is found to be primarily due to
anything other than the black streaks caused by blue-green algae, including, without limitation,
discoloration due to green algae, lichen, moss, mold, mildew, pollen, bird droppings, insect
infestations, and non-biological contaminants.
TRANSFERABILITY
You, the original purchaser of the product, can make full transfer of this warranty only one time, during the
Premium Protection Period (Premium Protection Period for each shingle is outlined herein in the Warranty
Details” chart) which begins on the date of original installation. This warranty cannot be transferred after
the Premium Protection Period expires. For this warranty to be transferred, the homeowner must complete a
Warranty Transfer Application by visitingAtlasRoong.com/Warranty, along with paying a transfer fee of one
hundred ($100.00) dollars within sixty (60) days after the date of the real estate transfer. If these terms are
satised, the second owner will obtain the benets of the original warranty. Proof of purchase of the Atlas
shingles and the installation date must be submitted with the online Warranty Transfer Application. Transfer
of this warranty shall not renew or extend the warranty terms, nor alter the warranty provisions, nor shall
any duplication of any previous claim be accepted. AFTER YOU HAVE TRANSFERRED THIS WARRANTY TO THE
PURCHASER OF YOUR HOME, IT MAY NOT BE TRANSFERRED AGAIN. THAT IS, THE PURCHASER OF YOUR HOME
MAY NOT TRANSFER THIS WARRANTY TO ANY SUBSEQUENT PURCHASERS. Warranty Transfer Applications may
be completed online by going to: AtlasRoong.com/Warranty.
WARRANTY REGISTRATION
To qualify for applicable Atlas Signature Select
®
warranty coverage, warranty registration must be completed
online by going to: AtlasRoong.com/Warranty. Your Registration must be completed at AtlasRoong.com/
Warranty within sixty (60) days of original installation. When applying for an Atlas Signature Select
®
Roong
System Warranty, you will be required to submit proof of purchase for all required Atlas products used.
CLAIM REPORTING PROCEDURE
Any claim made hereunder must be made within thirty (30) days after discovery of the alleged defect by calling
1-800-478-0258 or in writing to:
Atlas Roong Corporation
Attn: Consumer Services
802 Hwy 19 N, Suite 170
Meridian, MS 39307
To fully evaluate your claim we may ask you to provide and forward, at your expense, pictures of your shingles
and/or two (2) full shingle samples for us to test. Repairs made prior to or during the investigation period
without Atlas Roong Corporation’s prior written approval shall be at the owner’s expense. With all claims, the
original proof of purchase must be submitted, with any other claim information requested.
WARRANTY NOT VALID IF SUBMITTED INFORMATION IS ERRONEOUS OR FRAUDULENT.
Any claim for shingles that have been replaced prior to Atlas receiving written notication of the claim,
samples and inspection will be denied.
ATLAS SIGNATURE SELECT
®
PRODUCT SELECTION CHART: Use this chart to check that you have all of these required items before you register
online. If you have not installed all of the products below, please register your warranty under the standard Atlas Limited Shingle Warranty.
FAST & EASY WARRANTY REGISTRATION:
Atlas Roong Signature Select® Limited Warranty registration can be completed through our
easy-to-use online registration tool or by printing the application form and sending it through the mail.
To start the registration process visit:
AtlasRoofing.com/Warranty
Then choose your registration method:
Clicking on “Register By Mail” will provide you with a printable registration
form that should be lled out completely and mailed to Atlas:
Atlas Roong Corporation
Attn: Consumer Services
802 Hwy 19 N, Suite 170
Meridian, MS 39307
If you choose to register online, you’ll be asked to enter your email address. For your convenience, you
will receive a conrmation email with a link and a password, which will allow you to continue a paused or
incomplete registration. In addition, you will receive status updates from Atlas regarding the progress of
your completed registration.
Follow these four steps to complete your registration:
Identify products used in your new Atlas Signature Select® Roong System. Be sure to verify that
the products you are selecting match those used in your installation for each of the four required
categories as outlined in the Product Selection chart in this brochure. If you’re NOT sure of the
product, you must verify these products with your roong contractor or consult your invoices.
Enter requested information about the installation of the Atlas Signature Select® Roong System.
Enter contact information for both the owner and contractor (or installer) of the roof. Upload or mail
your invoices for this roof. The application cannot be completed until proof of purchase for all
required products has been received by Atlas.
Conrm your information and accept the Terms of Agreement on the warranty. Once submitted, you
will be able to print and/or download your application conrmation. Please keep this information
with your original receipt and proof of purchase.
Fast and easy online warranty registration — it’s just one more reason homeowners and roong
professionals prefer the Atlas Signature Select® Roong System.
Register Online
Register By Mail
1
2
3
4
Scotchgard and the Scotchgard Protector logo, including the plaid design and 3M logo, are all trademarks of 3M.
© Copyright 2019, Atlas Roofing Corporation ATL-184710-00 3/19
q StormMaster
®
Slate
With Scotchgard
Protector
q Atlas Pro-Cut
®
Hip & Ridge
Shingles With Scotchgard
Protector
q Atlas Pro-Cut
®
High Profile
Hip & Ridge Shingles
With Scotchgard
Protector
q Summit
®
60 Synthetic
Underlayment
q Atlas Pro-Cut
®
Starter Shingles
q WeatherMaster
®
Products
(for use on eaves
or valleys)
q StormMaster
®
Shake
With Scotchgard
Protector
q Pinncle
®
Pristine
With Scotchgard
Protector
q Briarwood Pro
q Castlebrook
®6
6
Where local building code requires, Atlas WeatherMaster®Ice & Water must be used as a fth product in order to qualify for the Atlas Signature Select® System
warranty for Castlebrook®.
Atlas Roof Shingles
(Must select one item)
Atlas Hip & Ridge Shingles
(Must select one item)
Atlas Premium Underlayment
(Must select at least one item - Atlas
underlayment must cover entire
roof deck surface)
Atlas Starter
Shingles
(Must select one item)
Atlas Ice & Water
(Must be used as a fth
product when choosing
Castlebrook®)
AtlasRoong.com/Warranty
4
Castlebrook® Wind Warranty: Standard 4-nail application is 110 mph wind warranty. Enhanced wind warranty to 130 mph with 6-nail application and the use of Atlas Pro-Cut® Starter Shingles installed along the eaves.
Refer to the Atlas Roofing Limited Shingle Warranty for all coverage requirements.
5
StormMaster® Shake Wind Warranty: Standard 4-nail application is 130 mph wind warranty. Enhanced wind warranty to 150 mph with 6-nail application and the use of Atlas Pro-Cut® Starter Shingles installed on all the eaves
and rakes and Atlas Pro-Cut® Hip & Ridge or Atlas Pro-Cut® High Profile Hip & Ridge Shingles. Refer to the Atlas Roofing Limited Shingle Warranty for all coverage requirements.