Manual

3.3 Ladder use safety
◆ Wooden ladder or FRP ladder shall be used when power climbing operation may be
involved.
◆ When using the herringbone ladder, the pulling rope must be firm, and someone
must hold the ladder during operation.
◆ Before using the ladder, please confirm that the ladder is intact, the bearing weight of
the ladder meets the requirements, and overweight is strictly prohibited.
◆ When using the ladder, the wide foot of the ladder shall face down or protective
measures shall be taken at the bottom of the ladder to prevent slipping.
◆ The ladder should be placed in a stable place. The gradient of the ladder should be
75 °, which can be measured with an angle ruler, as shown in the figure below.
◆ When climbing the ladder, please pay attention to the
following actions to reduce danger and ensure safety:
◆ Keep your body steady.
◆ The maximum height of operators standing on
their feet shall not exceed the fourth step of the
ladder from top to bottom.
◆ Ensure that the center of gravity of the body does
not deviate from the edge of the ladder.
3.4 Drilling safety
The following safety precautions shall be considered when drilling on the wall and
ground:
◆ Wear goggles and protective gloves when drilling.
◆ During drilling, the equipment shall be covered to prevent debris from falling into the
equipment. After drilling, the debris shall be cleaned.
3.5 Safety of handling heavy objects
◆ When carr ying heavy objects, be prepared to bear the load to avoid being crushed or
sprained by the heavy objects.
◆ When handling the equipment by hand, wear protective gloves to avoid injury.
3.6 Installation guidelines
◆ Determine the exact location of battery installation; If it is wall mounted, the wall
thickness shall be greater than or equal to 100mm;
◆ Use the mounting bracket or cardboard to determine the specific location of the hole;
Keep the top edge of the cardboard horizontal.
◆ Drill 6 holes at the marked position with the hole diameter of φ 8;The hole depth shall
not be less than 55mm.
◆ Knock 6 expansion screws into the drilled holes.
◆ Hang the battery mounting bracket on the screw.
10