Product Manual
Table Of Contents
- Table of contents
- 1 Safety precautions
- 2 General description
- 3 Elektronikon Base Controller
- 3.1 ElektronikonTM Base Controller
- 3.2 Control panel
- 3.3 Icons used on the display
- 3.4 Main screen
- 3.5 Main function
- 3.6 Shutdown warning
- 3.7 Shutdown
- 3.8 Service warning
- 3.9 Scrolling through all screens
- 3.10 Calling up running hours
- 3.11 Calling up motor starts
- 3.12 Calling up module hours
- 3.13 Calling up loading hours
- 3.14 Calling up load solenoid valve
- 3.15 Calling up/resetting the service timer
- 3.16 Calling up/modifying pressure band selection
- 3.17 Calling up/modifying pressure band settings
- 3.18 Calling up/modifying the unit of temperature
- 3.19 Calling up/modifying the unit of pressure
- 3.20 Calling up/modifying backlight time
- 3.21 Activating automatic restart after voltage failure
- 3.22 Keyboard lock
- 4 Installation
- 5 Operating instructions
- 6 Maintenance
- 7 Adjustments and servicing procedures
- 8 Problem solving
- 9 Technical data
- 10 Instructions for use
- 11 Guidelines for inspection
- 12 Pressure equipment directives
- 13 Declaration of conformity
If the service timer exceeds the programmed time interval, alarm LED (6) is blinking with a following
screen:
Blinking screen
• Press Enter button (7) to enter the main menu.
• Select <dAtA> and press Enter button (7) to enter the data menu.
• Scroll (buttons 4-8) until <d.6> and the service symbol is shown.
• Press enter button (7).
• The actual reading of the service timer is shown in <hrs>.
Example of running hours screen
The example screen shows that the service timer is at 2002 hours.
Stop the compressor, switch off the voltage and carry out the required service actions.
After servicing, reset the service timer.
See section Calling up/resetting the service timer.
Instruction book
2920 7191 00 35