Safety Information

IL-R V1 Safety Information
© Atlas Copco Industrial Technique AB - 9839 1630 00
5
(1) This device may not cause interference; and
(2) This device must accept any interference, including inter-
ference that may cause undesired operation of the device.
(French) Le présent appareil est conforme aux CNR d’Indus-
trie Canada applicables aux appareils radio exempts de li-
cence. L’exploitation est autorisée aux deux conditions suiv-
antes:
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromet-
tre le fonctionnement.
FCC and ISED Integration Instructions
FCC and ISED Integration instructions according to
KDB996369 D03 OEM V01 manual section.
2.2 List of applicable FCC/ISED rules used in the certifi-
cation of the IL-R
FCC:
• 47 CFR Part 15F (UWB)
• 47 CFR Part 15C (Bluetooth)
• 47 CFR 2.1091 (RF exposure)
ISED:
• RSS-220 (UWB)
• RSS-247 (Bluetooth)
• RSS-102 (RF exposure)
2.3 Specific operational use conditions
Not applicable. The IL-R have a printed PCB antenna.
2.4 Limited module procedures
The IL-R module is only to be used by the grantee in its own
products and is not intended for sale to third parties. Granted
Host product for this IL-R is ILT Base Station. Additional
hosts to be used must do a class II permissive change appli-
cation.
2.5 Trace antenna design
Not applicable
2.6 RF exposure considerations
Tested as a mobile device with 0.1 cm as the compliance dis-
tance meeting the power density requirements in the above
mention standards.
2.7 Antennas
Not applicable. The IL-R have a printed PCB antenna.
2.8 Label and Compliance information
Included in this documentation in section “FCC and ISED
compliance statement “and “ Labeling requirements for end
product”.
2.9 Information on test modes and additional testing re-
quirements
The IL-R module is only to be used by the grantee in its own
products and is not intended for sale to third parties. Granted
Host product for this IL-R is ILT Base Station which are
tested compliant to FCC part 15 B and ICES-001 for the un-
intentional radiator part of the host product.
2.10 Additional testing, Part 15 Subpart B disclaimer
The IL-R module is only to be used by the grantee in its own
products and is not intended for sale to third parties. Granted
Host product for this IL-R is ILT Base Station
Regional Requirements
WARNING
This product can expose you to chemicals including
lead, which is known to the State of California to cause
cancer and birth defects or other reproductive harm. For
more information go to www.P65Warnings.ca.gov
Useful Information
Website
Information concerning our Products, Accessories, Spare
Parts and Published Matters can be found on the Atlas Copco
website.
Please visit: www.atlascopco.com.
Country of Origin
For the Country of Origin, please refer to the information on
the product label.
Warranty
• Product warranty will expire 12 months after the product
is first taken into use, but will in any case expire at the
latest 13 months after delivery.
• Normal wear and tear on parts is not included within the
warranty.
• Normal wear and tear is that which requires a part
change or other adjustment/overhaul during standard
tools maintenance typical for that period (expressed
in time, operation hours or otherwise).
• The product warranty relies on the correct use, mainte-
nance, and repair of the tool and its component parts.
• Damage to parts that occurs as a result of inadequate
maintenance or performed by parties other than Atlas
Copco or their Certified Service Partners during the war-
ranty period is not covered by the warranty.
• To avoid damage or destruction of tool parts, service the
tool according to the recommended maintenance sched-
ules and follow the correct instructions.
• Warranty repairs are only performed in Atlas Copco
workshops or by Certified Service Partners.
Atlas Copco offers extended warranty and state of the art
preventive maintenance through its ToolCover contracts. For
further information contact your local Service representative.
For electrical motors:
• Warranty will only apply when the electric motor has not
been opened.