System information

117
4.4 RECORD
 Video Channel: Select the channel number to individually setup of each channel.
 Resolution: Select the resolution from CIF, Half D1 and D1 for individual channel.
 D1: 704*480 / 60fps (NTSC); 704*576 / 50fps (PAL)
 Half D1: 704*240 / 120fps (NTSC); 704*288 (PAL) (Default)
 CIF: 352*240 / 120fps (NTSC); 352*288 (PAL)
 Quality: Select the quality from Best, Fine and Normal for individual channel.
 Frame rate: Use this combo-box to adjust the frame rate from 0 to max value for individual channel.
The DVR will not be recording if the frame rate value is 0. In this option, you can set the
recording frame rate, if the frame rate which you set over system limitation, the system
will inform you that your frame rate can’t be accepted.
The 4CH device is able to record 100fps@D1 (then 25 fps for each channels).
The 8CH Divice is able to record using 200Power/Sec.
The 16CH Divice is able to record using 400Power/Sec (then 400fps@CIF)
Resolution
Power/Sec for each Frame
D1[ 704*576]
4
Half D1[ 704*288]
2
CIF [352*288]
1
 Channel: Select ON in order to record the channel, select OFF in order to don't record this channel.
 Rec Mode: Allow you select record modes, including Always (When Power UP) and Scheduled (By
Timer). To record 24 hours a day set the [Mode] to When Power UP. To record on motion or a set
schedule, select the By Timer option then click on Schedule button.
 File Length: The time for recorded video which was packed in 1 video file (15, 30, 45 and 60 min)
 Audio: Allows you turn audio on/off (ADPCM, 16bit, 8Khz).
 When powered on: starting recording when the DVR is energized (It works only if
the corresponding channel is enabled in the “Channel” option.)
 By time: performing recording as scheduled. When “timing recording” is selected,
the “Schedule” button will appear on the right. Move the cursor here and press
“Enter” to enter the Record Time Configuration screen, as shown below: