User`s manual

WebShare 340/440
44
checks these different filter rules one by one, stating from the first rule. As long as one of the
rules is satisfied, the specified action will be taken.
• Add TCP/UDP Filter: Click this button to add a new packet filter rule. After click, next
figure will appear.
• Add Raw IP Filter: Click this button to add a new Protocol Filter.
• Packet Filter Rules: On this table, you see packet filter rules; you can click on Edit to
modify rule or Delete
• Rule Name: Insert rule name; rule name must be different
• Time Schedule: It is self-defined time period. You may specify a time schedule for
your prioritization policy. For setup and detail, refer to Time Schedule section
• Source IP Address(es) / Destination IP Address(es): This is the Address-Filter
used to allow or block traffic to/from particular IP address(es). Selecting the Subnet
Mask of the IP address range you wish to allow/block the traffic to or form; set IP
address and Subnet Mask to 0.0.0.0 to inactive the Address-Filter rule.
• Type: Specify the packet type (UDP or TCP) that the rule will be applied to.
• Source Port: This Port or Port Ranges defines the port allowed to be used by the
Remote/WAN to connect to the application. Default is set from range 0 ~ 65535. It is
recommended that this option be configured by an advanced user.
• Destiantion Port: This is the Port or Port Ranges that defines the application.
• Inbound / Outbound: Select Allow or Block the access to the Internet
(“Outbound”) or from the Internet (“Inbound”).