User`s manual

WebShare 340/440

• Authentication Protocol Type: Default is Chap (Auto). Your ISP will advise you

whether to use Chap or Pap.

• Always on: If you want the router to establish a PPPoE session when starting up and

to automatically re-establish the PPPoA session when disconnected by the ISP.

• Connect to Demand: If you want to establish a PPPoE session only when there is a

packet requesting access to the Internet (i.e. when a program on your computer

attempts to access the Internet).

• Idle Timeout: Auto-disconnect the broadband firewall gateway when there is no

activity on the line for a predetermined period of time.

• Detail: You can define the destination port and packet type (TCP/UDP) without

checking by timer. It allows you to set which outgoing traffic will not trigger and reset

the idle timer.

• RIP: RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.

• MTU: Maximum Transmission Unit. The size of the largest datagram (excluding

mediaspecific headers) that IP will attempt to send through the interface.