User manual

Page 119
S
S
t
t
e
e
p
p
5
5
:
:
From the Start menu, click Run and type cmd. When the
command prompt window appears, type in the following
command:
X:\recovery\TFTP -i 192.168.168.1 PUT image_name.IMG,
where X refers to your CD drive and image_name.IMG
refers to the firmware filename found in the Recovery
folder of the Product CD.
S
S
t
t
e
e
p
p
6
6
:
:
If you have downloaded a newer firmware and have
saved it in your local hard disk as:
C:\accesspoint\accesspointxxx.IMG, then replace the
command with this new path and firmware name. For
example:
C:\accesspoint\TFTP –i 192.168.168.1 PUT
accesspointxxx.img
The recovery process takes place.
You can monitor the progress of the recovery process
with the diagnostic LED.
When firmware restoration is complete, reboot the access
point and it will be ready to operate.