Instruction manual
8
P-2000 7.1 Channel Preamp/Processor/Tuner
Instruction Manual
9
P-2000 Rear Panel
Below is a brief explanation of the connections and switches found on the
P-2000 rear panel. Before connecting any audio or video components to the
unit, familiarize yourself with the type and location of connectors available.
1 FM Antenna terminal (see page 20)
Use to connect the supplied FM antenna or an external 75 Ω antenna.
2 AM Antenna terminals (see page 20)
Connect the supplied AM loop antenna or an external AM antenna to
these terminals.
3 Remote Trigger jacks (see page 21)
Use the MAIN and ZONE DC TRIGGER jacks to control external devices
(such as a power amplier) with a 3-32 VDC trigger input. The device
connected to the MAIN jack will be activated when the P-2000 is turned
on and should be used for connections to power ampliers or other
devices in the main room. The device connected to the ZONE trigger
will only be activated when the Multi-zone system is turned on. Connect
it to the amplier or other devices used in the second zone.
4 Remote Control jacks (see page 21)
Use the MAIN and ZONE EXT REMOTE jacks to connect external IR
sensors to the P-2000. When the unit is installed behind doors or where
it is not otherwise visible to the handheld remote, connect an optional,
external sensor to the MAIN jack. To control the Multi-room system
from a remote location, connect an optional remote sensor in the second
room to the ZONE EXT REMOTE jack.
5 Component Video Input jacks (see page 19-20)
Use these two sets of jacks to connect devices with component video
outputs such as a DVD player or HDTV tuner.
6 S-Video jacks (see page 19-20)
Connect the S-Video output of sources to the appropriate input jacks.
Connect the VCR-OUT jack to the input of a VCR or other recorder and
connect the OUT jack to an S-Video input on your video display device.
7 Component Video Output jacks (see page 19-20)
Use these jacks to supply component video output to an external monitor
that accepts component video signals. (Note that the OSD is not avail-
able on the Component Video Output as it could potentially degrade
the video signal.)
8 5.1 Channel Input jacks (see page 21)
Connect the multi-channel signal from the analog audio outputs of a
device such as a DVD, DVD-A or SACD to these jacks.
9 Digital Outputs (see page 20)
Use the coaxial and optical digital outputs to connect the preamp/
processor to a device such as CD recorder, DAT recorder, or other similar
device that accepts a digital audio input. These jacks automatically output
the signal from whichever digital input has been selected for listening.
10 Optical Digital Inputs (see page 19-20)
Use these inputs to connect the optical digital audio signal output from
such digital devices as CD, DVD or LD players. These inputs are fully
assignable.
P-2000 Rear Panel
P-2000 Rear Panel
�
1 112 65
3
19 2112 14 15 17 20
4 7 9
13
10
18
8
16