Instruction manual
6
P-2000 7.1 Channel Preamp/Processor/Tuner
Instruction Manual
7
in the FRONT PANEL DISPLAY or the ON SCREEN DISPLAY and then
press the button again to select the next channel in sequence.
10 SOURCE buttons (see page 30)
Press either of these buttons to toggle through the input sources available
and select the one you wish to listen to.
11 On/Standby/Mute indicator (see page 22, 30)
Lights to indicate when the unit is in Standby mode and goes out when
the preamp/processor is active. Also ashes to indicate when the main
system volume is muted.
12 MULTI indicator LED (see page 29, 36)
Lights to indicate that the second zone (Zone 2) is active. Note that this
light will remain lit even when the other indicators are off, as long as the
second zone is active.
13 PRESET SCAN button (see page 32)
Pressing this button scans the receivable AM or FM stations stored
in the tuner’s preset memory, stopping briey (5 seconds) at each.
Pressing it again stops the scan at the preset indicated in the FRONT
PANEL DISPLAY. The unit’s input source automatically changes to Tuner
when this button is pressed.
14 MEMORY button (see page 32)
Pressing this button when FM or AM is selected as the input source stores
the current station frequency into one of the presets. You can preset up
to 32 randomly mixed AM or FM stations.
15 MENU button (see page 22)
Enters the Menu mode and displays the menu options on the FRONT
PANEL DISPLAY and the ON SCREEN DISPLAY (OSD). Press the button
again to exit the Menu mode.
16 Navigation buttons (see page 22)
When in Menu mode, use these buttons to navigate through the menu
options displayed on the FRONT PANEL DISPLAY or the ON SCREEN
DISPLAY (OSD). These buttons are also used to change options or set-
tings with some of the front panel controls.
17 SELECT button (see page 22)
When in Menu mode, selects the menu options displayed on the FRONT
PANEL DISPLAY or the ON SCREEN DISPLAY (OSD).
18 SURR MODE buttons (see page 31)
Press these buttons to select among the various surround modes pro-
vided by the P-2000. The Modes available depend on your system’s setup
conguration and the chosen input source.
19 VOLUME control (see page 30)
Adjusts the volume level for the main zone only. Remote zone (Zone 2)
is not affected by this control.
20 MUTE button (see page 31)
Mutes the Main System volume. The STANDBY/MUTE indicator ashes.
Pressing the button again returns the unit to the previous volume setting.
The STANDBY/MUTE indicator goes out.
1 1098765432
20191817161514131211
P-2000 Front Panel
P-2000 Front Panel